Failing to Protect The Loops In Your
Radiant Heating System!
For decades, in-floor radiant heating systems have been extensively used in Europe. Many
people that have chosen a radiant heating system are aware of how comfortable, quiet and
cost-effective radiant heat is to operate.
Yet, with poor design and installation of a radiant heat system certain areas of your
home may be cold, while others are hot. To ensure that your system will maintain a
comfortable and uniform temperature, professional design and installation by a qualified
in-floor radiant heating expert is advised.
With radiant heat, uneven circuit lengths, insufficient tube size, improper tubing
depths, and poor circuit layout can all affect individual areas, but I find that the most
common problem with an in-floor radiant heating system stems from not properly positioning
or installing bend protectors.
In fact, that’s what happened to Fred and Deb Buckley. They had to tear up part of
their flooring because with their radiant flooring system the right side of their home was
much colder than the left side.
You see, in larger homes or buildings it is quite common to break down a radiant heating
system into three or more zones, each one providing a comfortable interior temperature
control.
The proper zoning of a heating element, such as in-floor radiant heat, must take into
consideration the size of zones, positioning of zones, direction the room faces, as well as
the location of the thermostats for each individual zone.
Similar to all construction, it becomes vitally important to coordinate the trades so
that problems are avoided.
With an in-floor radiant heating system, your radiant heat contractor may have designed
the system properly. However, the concrete contractor pouring the slab may damage or
adversely affect the performance of the system.
As well, many lackadaisical radiant heat installation teams don’t take the care
needed to do a suitable job. I hate to say it, but I have personally heard other contractors
instruct their radiant heat staff to ignore kinks and rush through jobs, in hopes of a
future repair call.
If there is a crimp or blockage it will affect the flow of fluid through your radiant
heat line. A crimp will restrict the flow of fluid in the radiant heat tubing and the
section of floor following the crimp would not get enough fluid to heat up properly, thus
keeping it colder than the other.
That’s why bend protectors become so important. Anytime your radiant heat tubing
needs to make a sharp turn, the bend becomes venerable. It’s the bend protectors that
safeguard the radiant heat tubes from kinking and ensures that water can continuously flow
though them.
Another thing to consider; if your radiant heat lines are not well supported prior to the
pouring of the concrete, or are “sagging” between supports, then the thickness
of concrete above the lines will vary resulting in a non-uniform heat distribution.
If Fred and Deb had a radiant heat installer that believed in doing the best job
possible, chances are they would have avoided the added expense of tearing up their flooring
to fix the problem. Although they are now enjoying an even heat distribution, it was a
costly error that could have been avoided.
When radiant heat is installed properly, bend protectors will eliminate many of the
problems associated with cold and hot spots.
-- Resource Box --
This article may be distributed freely on your website, as long as this entire article,
including links and this resource box are unchanged.
